I call it the Pink Delta. The Pink Delta came from a variation of the Mugi Evo.
List of parts
- AX 2306N 2000kv brushless Micro Motor
- GWS EP Propeller (DD-5043 125x110mm)
- H-KING 10A Fixed Wing Brushless Speed Controller
- FlySky 2.4G 6-Channel Receiver (R6B) for CT6B 6-CH TX
- 2mm Gold Connectors 10 pairs (20pc)
- Gens ace LIPO 800mAh 20C 11.1V lipo battery pack
- Old Hitec 5.5g servo (Smaller servos would probably work)
- Piece of 4x8' pink foam from the Homely Despot
- Pushrod and hardware I had laying around
- 3/8" square dowel from the Homely Despot
- Gorilla glue and hot glue
- Packing tape
The dimensions of the Pink Delta match the Mugi Evo, except instead of hard to find 2mm coroplast, I used readily abundant 1/2" pink foam insulation from Home Depot.
- Cut a corner off of the 4x8' sheet of foam, by measuring 800mm/sqrt(2) = 565mm on both sides from the corner, and cutting across the two marks.
- Draw out and cut out the elevons and verticle stabs
- Glue on verticle stabs. I tried to angle them out, but they are quite uneven. I think next time they will be 90deg straight up
- Bevel elevons with razor and back of main delta section to allow full movement of the elevons once installed
- Using packing tape, or 3m tape with nylon fibers, install the elevons
- Glue reinforcement onto nose. I used some thin plywood I got from the Home Depot scrap bin
- Glue motor mount on. The selected motor is a stick mount, so I used a 3/8" dowel from Home Depot and glued it right down the centerline. I plan on switching the motor around to keep the thrust line at the same level as the airframe to hopefully improve handling
- Cut holes for servos, battery, receiver, and whatever else you need.
- Mount servos, control horns, and electronics. I had some 2-56 pushrods with ball ends for the elevons. The ball joints work fairly well. Most of the electronics are held down with sticky strips of hook and loop material.
- Charge battery and fly!
I chose not to round the leading edge of the wing to save time due to fear the thing would fly like a rock. It does fly kind of like a rock. Maybe a light one like pumice.
Flies quite interestingly. The Pink Delta, despite no dihedral, will not flip or roll. The think does not want to go upside down. The controls are overly sensitive, when I get around to it I will add a little expo to th controls.